![]() ![]() Here you will find the required miter and tilt cuts necessary for other angles. If you wish your roof to be at a different angle see segmented wood turning. When assembled, the roof will be at a 43 degree angle. When finished each piece should be approximately 5.5″ x 5″ (14cm x 12.5cm). ![]() See Bird House Hole Size if you want to attract a specific bird.Ĭut six pieces for the roof with a 21.5 degree tilt and a 21.5 degree miter cut. However, chickadees, nuthatches, warblers, woodpeckers, and wrens will also gladly make this their home. A 1.5″ (4 cm) entrance hole is the optimum diameter for bluebirds and tree swallows. Drill the entrance hole for the birdhouse.ĭrill a hole for the entrance using either a spade bit or forsnter drill bit. Each piece should be 6″ x 3.5″ (15cm x 9cm). Create the sides of the gazebo bird house.Ĭut six pieces for the sides on a table saw or miter saw with the blade set at a 30 degree tilt. If so, when assembling leave a small gab between the two pieces for drainage. Note, two smaller pieces of wood can also be used for the bottom. Drill several 1/4″ (0.5 cm) holes in the floor for drainage. The distance from one side to the other side should be 7″ (18 cm). Prepare the base or the bottom of the bird house.Ĭut a 6-sided (hexagon) using a miter saw, table saw, band saw, or other saw. Drill bit to match appropriate entrance hole size.Wood (cedar, redwood, cypress, and pine would make good choices).Materials and Equipment Needed to Build this Birdhouse: Find more free bird houses plans or discover more nesting boxes and bird feeders. This birdhouse can be used to attract bluebirds, swallows, chickadees, nuthatches, warblers, woodpeckers, wrens, and other birds to your backyard or garden. Free DIY bird house plans to make a gazebo (6-sided) hexagon nesting box. ![]()
0 Comments
Leave a Reply. |